I have a float that gets stuck up, so want to remove it and investigate what's going on. But access to it is a real chore. Can I unbolt the two screws that hold the black plate that attaches to the hull, to get the float and pump out to a side? Or are those screws a real pain and meant to be a one time only install into the hull? See pic. The two screws are in the front of the pic.
Alternately does anyone know a trick to take off the Rule float easy? I know the bilge pumps lift out of the cartridge, but not sure if there is a trick to get the main body of the float off.
Need to service a bilge float. Can I unscrew the panel it's mounted to?
Need to service a bilge float. Can I unscrew the panel it's mounted to?
You do not have the required permissions to view the files attached to this post.
2010 Cobalt 232 8.1Gi
Re: Need to service a bilge float. Can I unscrew the panel it's mounted to?
.
You can definitely get those screws out and slide the entire assembly platform out. It’s actually easier that way. Use a right angled screw driver.
You can definitely get those screws out and slide the entire assembly platform out. It’s actually easier that way. Use a right angled screw driver.
2002 Cobalt 262
&
2005 Cobalt 263
496 MagHO
(sold )
Erie, PA
Currently boatless (for now)
will fly for food
(CChat moderator)
&
2005 Cobalt 263
496 MagHO
(sold )
Erie, PA
Currently boatless (for now)
will fly for food
(CChat moderator)
Who is online
Users browsing this forum: No registered users and 1 guest