Rubber Spacers / Bumper

[Southernboatman]

Yeah I have a pretty good supply stock around here but will get online if needed. "Luck" of being in an area with lots of water and boats. That part seems to be a standard go to for a lot of manufacturers.

[Bobo87]

When you ordered these from Lodder Marine do you have a part number or name? How much were they? I need them too. Was about to ask but found this old thread.

[Big Block Power]

Nauti got me some from lodders. I think they were like $7?
I put three on the 222.

[cmattj]

Geeze .. I could not find a threaded bolt to replace mine.. every thing in stainless had a shank so I could not adjust it down.

Stainless carriage bolt + grinder walah instant bolt head.. not pretty but it worked

[Big Block Power]

Geeze .. I could not find a threaded bolt to replace mine.. every thing in stainless had a shank so I could not adjust it down.

Stainless carriage bolt + grinder walah instant bolt head.. not pretty but it worked

Yours was missing the bolt? One of mine won't adjust but it's close enough not to worry about it.

[cmattj]

Geeze .. I could not find a threaded bolt to replace mine.. every thing in stainless had a shank so I could not adjust it down.

Stainless carriage bolt + grinder walah instant bolt head.. not pretty but it worked

Yours was missing the bolt? One of mine won't adjust but it's close enough not to worry about it.

Missing.. and with the shank a top set nut would not let it drop.. California oaky buddy..

[Driller]

When you ordered these from Lodder Marine do you have a part number or name? How much were they? I need them too. Was about to ask but found this old thread.

No, I just described what I wanted and they knew right away. Don’t remember the cost, but I think the shipping was about half of the total. I went ahead and replaced all of mine and bought a few spares.