Cobalt Boats Forum

Sounds crazy but you may try your local Tractor Supply, Murdoch's, Back 40, etc for something quick. You would need to get a little creative on the fill and drain but most are necks that thread in to a hole you drill. Also RotoMold on line. I run herbicide sprayers and have had to replace specialty ...

Hello all.

Looking for replacement stainless steel railing that goes around the rear of the boat and incorporates the tie down. Mine was damaged by previous owner. Insurance paid to have replaced but whoever built new ones, from out of Seattle area I believe, did a very poor job. Probably a long ...

Hi all.

Boat in question is a 1994 Cobalt 272. I'm attempting to replace a old rectangle Lowrence 3200 depth sounder with glued in transducer.

I purchased a Hawkeye depthtrax 2bx that comes with a transom mount transducer which I'm not sure I'd want to use. I've read where people have glued a ...

Sorry for the huge delay. Life.. it's him across this again when trying to determine if I can put it through hole transducer and my 272. Called Cobalt and they didn't say no but they said be careful doing it. So it really didn't tell me much of anything.

Hi all.

Boat in question is a 1994 Cobalt 272. I'm attempting to replace a old rectangle Lowrence 3200 depth sounder with glued in transducer.

I purchased a Hawkeye depthtrax 2bx that comes with a transom mount transducer which I'm not sure I'd want to use. I've read where people have glued a ...

"Dear (aka)TechieTechie ,
Thank you for your e-mail. That is an excellent question. I have been here at the factory for over 35 years and spent 15 of it building the
boats. We actually did not start using fiberglass stringers until the 252 came out in 1994. The composite liner floor came out at ...