Cobalt Boats Forum

Check the play in your gimble housings. It is a common problem with Bravo threes. You always need to keep the top bolts torqued to 100 lbs. If they become loose and are driven it wears the housings and need to be replaced.

I figured my trim switch problem. It was one of the pins in the wiring harness not making contact.
Thanks for all your help.

I have captains call but it has the switch on the dash.
I flip these switches but do not hear anything or have found anything they might work.
I just purchased this boat and trying to learn about things.
So you are saying it is for the fresh water pump?
What runs the pump for the drain in the ...

Can someone please tell me what these accessory switches would run on a 293?

I'm going to check into this more it has me puzzled.

The trim tab buttons on my boat are up by the dash.
Yes the drives only go down with the button on the throttle.
They can still go down more and I'm assuming that when they go down far enough they will go up until the limit switch stops them.
Than the trailer button function should work? Where ...

Sorry for the delay in responding I'm new to this. Here is a picture of the boat.

Hello
My boat has twin Mercrusier 6.2 with bravo three drives. The controls are like in a offshore with the two throttle and two shifter levers. The trim button for both drives is on the one throttle lever. The two rocker switches are by the fire extinguisher.

Hello I just purchased a 2001 293 cobalt and I have a question about raising my drives up on the trailer. Where is the trailer button? They went down with switch on the throttle but can't seem to raise them up. I tried using the toggles on the side by the fire extinguisher but I get nothing.
Please ...