New to forum

[F. McGinn]

Just getting started with this 97'Cobalt 23ls. I was told it's been setting for 3 years. What are all the things i need to check and change. I've changed all the fluids and purchased new bellows and gimbal bearing, but curious on water pump impeller (which one to get) 97'23ls 7.4 volvo penta dp out drive

[jhnmdahl]

In order to have high confidence you're getting the right impeller, we would need to know the full model number of the engine (e.g. 7.4GLNIC instead of 7.4L) A lot of impellers are sold under different brand names and different model numbers, which also makes it difficult, and some like 21951346 are no longer made but substitute to another part number. Volvo-branded ones are fine, and people have had good luck with quality aftermarket brands like Sierra and Johnson.

My favorite place to look up stuff like this is marinepartseurope.com, who have pretty thorough parts catalogs online.

[F. McGinn]

Thank you. I can't read Volvo tag on motor, so I'll have to find my manual and see if it's logged in there. Boat was given to me from my cousin. It's out of Austin, Tx and always in fresh water but he let it sit for at least 3 years. I have pics of pump and tags, but haven't figured out how to upload yet Thanks again

[jhnmdahl]

To upload pictures, you need to use the "Full Editor & Preview" button below the text box - that'll bring you to a window where you can add a photo as an attachment (look below the text entry box), and choose where in the post to put each attached photo.

[F. McGinn]

Hope this goes where it's supposed to

[F. McGinn]

Can't read anything on it

[F. McGinn]

Thanks for the help. That seemed to work!

[AsLan7]

.
So glad you found us F.M….

Don’t forget the batteries as well.

How old is the trailer? Looks fairly new. If not , be sure to check the trailer bearings.

And welcome aboard mate.

.

[Kate]

"Can't read anything on it"

A couple ways to tackle this: 1) Clean the tag with solvent, then take a picture with your phone. If needed, use the flash then photo editor. I've seen that work. 2) The number is also stamped on the block, perhaps starboard back. 3) Contact a dealer with your HIN. They might be able to look it up. 4) Use the spy method: Clean tag, cover with tracing paper, gently rub paper with side of pencil.