Cobaltchat.com

So I sent back one pair of Rev10s and used the SDX4 to power the remaining 2 (370w each). My dealership sent me a little teaser video. This is not even at 25% volume! Glad I went with one pair.
.

.


.

That's pretty sweet.

I am looking at adding 2 Rev10's, adding an amp, and I have the same folding tower as pictured on my R7. What bracket mounts did you use? Also, were the tower wires ran and if not how hard were they to run? I also have to agree on Creative Audio, the are great! TIA

You need to use the swivel clamps. The configuration of the tower will have the speakers pointed outward so you have to have that clamp so they can turn them slightly. In my case the wires were already run because I took out the Roswell tower speakers which in my opinion sounded very poorly. I took out four of those and replaced them with two REV 10 speakers and sound is phenomenal. I also put the LED rings on the speakers. It adds a very nice touch.

Thanks, for the reply. I initially ordered the platinum package without the tower speakers. This is a winter project for me while I am barn boating and dreaming of being back on the water!

Soonerfan wrote: Thu Sep 26, 2019 8:46 am Thanks, for the reply. I initially ordered the platinum package without the tower speakers. This is a winter project for me while I am barn boating and dreaming of being back on the water!

Cobalt prewire's the towers so you should have speaker wire already in the tower. I have pulled the grommets from mine and indeed found speaker wire in there.