Page 2 of 2
Re: Applying emblem letters
Posted: Sat Oct 02, 2021 9:59 am
by Dudley67
If you want the easy way out…
Part #452696 is one side of the complete Chrome letters, not flat, they have a raised ridge on them. These are 3” letters. One complete set already spaced out, just remove each letters’ tape backing, press, an then peel off the top plastic
Applied on our 226.
393AA7C8-D0DD-413B-B636-1F69C9373A00.jpeg
Re: Applying emblem letters
Posted: Sat Oct 02, 2021 3:29 pm
by Big Block Power
Dudley67 wrote: Sat Oct 02, 2021 9:59 am
If you want the easy way out…
Part #452696 is one side of the complete Chrome letters, not flat, they have a raised ridge on them. These are 3” letters. One complete set already spaced out, just remove each letters’ tape backing, press, an then peel off the top plastic
Applied on our 226.
393AA7C8-D0DD-413B-B636-1F69C9373A00.jpeg
I'll give you 20 bucks. Lol
You know how many pm messages I get asking if I have any. Arggg oh for anyone reading this. No I don't.
Re: Applying emblem letters
Posted: Sat Oct 02, 2021 5:46 pm
by Dudley67
Maybe we should open a e-store for letters….
Re: Applying emblem letters
Posted: Sat Oct 02, 2021 7:50 pm
by Big Block Power
Dudley67 wrote: Sat Oct 02, 2021 5:46 pm
Maybe we should open a e-store for letters….
Right. I used to sell the crownline decals. Also did the checkerboard for them too.
Re: Applying emblem letters
Posted: Sat Apr 23, 2022 4:43 pm
by Titaniumboy
Here are some hints for attaching emblems back on.
