R7 bow cushion issue

[Dadof3girls]

I have a 2020 R7 with the bow filler cushion. I keep it in all the time but it will almost always end up falling out due to the bolt thru coming loose. I know this has to be a common issue. Has anyone found a good way to keep it from becoming dislodged and the cushion from falling to the floor?

[Tuscany]

Ours fell out in the first hour LOL.
The bolt unlocks from gravity and eventually falls out.
Kind of a dumb choice of a slide bolt from Cobalt. Not to mention the potential damage this issue could cause..
Get some Gorilla tape, rip off a foot of it for each bolt, get under there and tape the bolt lock shut. It’ll never fall out again.

[Norris_Boating]

Ours fell out in the first hour LOL.
The bolt unlocks from gravity and eventually falls out.
Kind of a dumb choice of a slide bolt from Cobalt. Not to mention the potential damage this issue could cause..
Get some Gorilla tape, rip off a foot of it for each bolt, get under there and tape the bolt lock shut. It’ll never fall out again.

Same issue, same solution here!

[Krob1114]

I'm a duct tape man myself. If the Egyptians would have had duct tape, the Spinx would still have it's nose.

[Tuscany]

I'm a duct tape man myself. If the Egyptians would have had duct tape, the Spinx would still have it's nose.

[Dadof3girls]

Thanks guys! Before seeing this I put a zip tie thru the same hole as the bolt and it had also seemed to work so far. I think the tape would be a little better solution though. I may go to that if mine doesn’t hold up.