Flag Mount Installation

[stevea207]

I've got a 2019 R5, looking to install a stern flag mount. This forum suggests TigTech, and they have a mount that looks easy to install but does require a hoe saw drill into the boat, 1 1/4 hole at a 20 degree angle. Seems like a fairly easy install, and I am moderately handy, just reluctant to start drilling into the boat. Anyone do it themselves? Best mounting spot? Thanks for the input.

[Big Block Power]

Yes you have to drill a hole. They used to supply the flag and pole to Cobalt before Cobalt went to another source that wasn't local to them.
Matt had a great post on here on it. Maybe A7 can find that one? Then put it in the factory spot.

[AsLan7]

I've got a 2019 R5, looking to install a stern flag mount. This forum suggests TigTech, and they have a mount that looks easy to install but does require a hoe saw drill into the boat, 1 1/4 hole at a 20 degree angle. Seems like a fairly easy install, and I am moderately handy, just reluctant to start drilling into the boat. Anyone do it themselves? Best mounting spot? Thanks for the input.

.

Yes you have to drill a hole. They used to supply the flag and pole to Cobalt before Cobalt went to another source that wasn't local to them.
Matt had a great party on here on it. Maybe A7 can find that one? Then put it in the factory spot.

.

.
Your wish is my command…..Flag install.



.

[stevea207]

Wow, thanks so much-- just what I needed-- Thanks AsLan7

[AsLan7]

Wow, thanks so much-- just what I needed-- Thanks AsLan7

.
You’re welcome my friend. Take a pic or two to add to it. We love pics here. ….(and any other helpful advice you can offer. )

[Holy Smokes]

I made a guide for my 360. Drill the 1 1/4" diameter 90* through a 4x4 block. Then cut through the hole at 20* on a miter saw. Double-stick tape the cut face to the surface. Voila!

I probably have the block and the hole saw in my shop. You're welcome to use it.

[dustinm]

I made a guide for my 360. Drill the 1 1/4" diameter 90* through a 4x4 block. Then cut through the hole at 20* on a miter saw. Double-stick tape the cut face to the surface. Voila!

I probably have the block and the hole saw in my shop. You're welcome to use it.

Pure genius. Are you some kind of electrical engineer?

[Holy Smokes]

I made a guide for my 360. Drill the 1 1/4" diameter 90* through a 4x4 block. Then cut through the hole at 20* on a miter saw. Double-stick tape the cut face to the surface. Voila!

I probably have the block and the hole saw in my shop. You're welcome to use it.

Pure genius. Are you some kind of electrical engineer?

HA! more construction & over-thinker & anal about drilling holes in the boat background.