2004 240 depth finder question.

[Snowman8]

I am asking for a friend as I have an R5 but they have a 2004 240 that the depth finder quit working. The gauge will read 0 to about 2 feet give or take and the low depth alarm goes off until it it silenced. They can’t seem to find the transducer to check if the fluid has dried up or leaked out of the mount, can anyone tell me where it is located? Also does anyone have any other ideas of what the possible problem could be?

[Big Block Power]

Snowman this was just posted in another thread. Lol just saying for a friend
A7 will attach that link.
It's under the engine by the motor mount area probably starboard side.

[Snowman8]

Snowman this was just posted in another thread. Lol just saying for a friend
A7 will attach that link.
It's under the engine by the motor mount area probably starboard side.

Thanks! I guess I didn’t look around enough!

[Big Block Power]

Snowman this was just posted in another thread. Lol just saying for a friend
A7 will attach that link.
It's under the engine by the motor mount area probably starboard side.

Thanks! I guess I didn’t look around enough!

It was a 262 post. Same crap. A7 posted a picture of it with his motor out.

[AsLan7]

Snowman this was just posted in another thread. Lol just saying for a friend
A7 will attach that link.
It's under the engine by the motor mount area probably starboard side.

Thanks! I guess I didn’t look around enough!

It was a 262 post. Same crap. A7 posted a picture of it with his motor out.

'\
Yes...posted here and here.

.