‘19 R7 Check Engine

[tbully]

Hi All -

2019 R7 w/ 430

Check engine light / message comes up randomly. Usually during a 15+ min drive at constant speed around 25mph.

Other times, pulling tubes, wake boards, etc, there are no issues.

Boat seems to run fine. Normal pressures and temps.

Code/warning clears with restart. It’s just a single beep or two.

Still running last year’s (stabilized) fuel. Yeah, I know. Slow start. LOL

I’d like to purchase a code reader to have on-hand to get an idea of what’s going on. Google shows dozens of choices from $60 -$600+. Any suggestions on a solid unit? Not afraid to pay a little to get a reliable tool. Very familiar with automotive OBDII, emissions systems, etc but marine is foreign to me.

(Or ideas on the warning?)

Thanks all! Hope your summer is going well!

[stifflkd]

Should be able to retrieve the code with your Easy Connect app or the EVC display. Keep engine running when retrieving. You will lose the data once you remove power.

[tbully]

Thought so as well. I go to the fault page and hit “ok” but it doesn’t do anything. (Referencing a few videos and write ups)

[bruceb58]

Rinda Diacom is the best! It's what I own.

[stifflkd]

Thought so as well. I go to the fault page and hit “ok” but it doesn’t do anything. (Referencing a few videos and write ups)

I follow this procedure and it brings me to the fault code page.

[tbully]

That’s the video I referenced. I hit “ok” from the fault page but nothing happens. Will try again when it sets the next code.

I think I briefly feel a loss of power and a change in the exhaust sound when it happens (only happens for a second or so)

I will also look in to the reader suggested above. Thank you!

[stifflkd]

That’s the video I referenced. I hit “ok” from the fault page but nothing happens. Will try again when it sets the next code.

I think I briefly feel a loss of power and a change in the exhaust sound when it happens (only happens for a second or so)

I will also look in to the reader suggested above. Thank you!

Did you double click the OK button to read the fault code?

[tbully]

That’s the video I referenced. I hit “ok” from the fault page but nothing happens. Will try again when it sets the next code.

I think I briefly feel a loss of power and a change in the exhaust sound when it happens (only happens for a second or so)

I will also look in to the reader suggested above. Thank you!

Did you double click the OK button to read the fault code?

I did. But perhaps I wasn’t patient enough. (Kids yelling to continue tubing. )