2013 200 Issues

[moosenuckle]

I am a new owner of a 2013 Cobalt 220. I am experiencing a few issues with the boat that I thought someone here may can help me.
1) Cannot remove key from ignition
2)Trim tab guage not working on dash. What should i check first?
3) Backlighting on instruments guages not working?

Thanks for any and all help

Thanks

[cmattj]

I am a new owner of a 2013 Cobalt 220. I am experiencing a few issues with the boat that I thought someone here may can help me.
1) Cannot remove key from ignition
2)Trim tab guage not working on dash. What should i check first?
3) Backlighting on instruments guages not working?

Thanks for any and all help

Thanks

Ignition switch .tumblers inside cylinder stuck dry or key is bent. Replace it as a assembly

Trim gauge uses senders in the outdrive so send 12vto gauge to check sweep and or sender is junk.

Backlighting can be default off in some models for nighttime. You may have up buttons once key is on to illuminate them.

Get some pics and head over to the new members section as you’ll be greeted by everyone and owners of your model will chime in!
Also is the a fresh or salt water used Cobalt?

[moosenuckle]

Thanks for the info

It is a fresh water boat

[Big Block Power]

Welcome. Pics or it doesn't exist.
First is it a 200 or a 220?
Try ed in the lock cyl. Lije Matt said key bent? Tumblers stuck? May have to replace it.

Lights? Is the switch turned on. Lol
Sorry had to go there. Check the ground to them or power. That could also be the issue with the trim guage. Or like Matt said the sender is bad or wiring to it. Is it a merc or vp?

[moosenuckle]

Sorry it is a 220 with Volvo

[Big Block Power]

Also make sure the circuit breaker is reset for the lights. Do the courtesy lights work.
So if the boat is red you get Matt and Nauti's help and the rest of the candied red group. If it's black you get myself, Yt,A7 and the rest of black brigades help!

[Driller]

You've probably checked this, but my 2011 242 has a dimmer switch under the helm where the gauges can be dimmed. Any chance the gauges are just dimmed all the way down?

#21 in the screen shot.

[Big Block Power]

Interesting driller. I wonder what year they added dimmers.

[ajcampen]

Interesting driller. I wonder what year they added dimmers.

I have a dimmer!?!

[Driller]

Interesting driller. I wonder what year they added dimmers.

Wouldn’t know, but it is a nice feature. Kinda hidden though. I’m a little bit nerdy and tend to read all my owners manuals. That’s the only reason I knew it was there.

[hawranek]

Interesting driller. I wonder what year they added dimmers.

My 2007 212 has a dimmer too But it is impossible to dimmed it all the way down to shut the lighting off

[moosenuckle]

I tried the dimmer yesterday and still no instrument lighting. The trim guage will show movement when i trim up and down but it is not accurate

[Big Block Power]

Sounds like you need a new sender on the drive. Pretty common. Do the courtesy lights work?

[moosenuckle]

The courtesy light do work

[Big Block Power]

Then i would check for power and ground at the guages. There is a power bus link tucked in the side of the helm. You may have to remove helm access panels to get to it.