Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
DockRocker wrote: Tue Jul 14, 2020 3:45 pm
It does stick out about a quarter inch on each side below the hull. I am keeping a close watch on it for now. The lights are offset, so I could remove the Y fitting and just use one of the offset Diablo Royale lights if I think that would be better, safer. Right now, I'm leaving both lights and the Y fitting in.
.
Yes....be careful with that. We hit a submerged something last week (some type of wood) and it went way up into our pitot tube on the outdrive. Had to dig (actually drill) fairly deep to get it out. Heard it hit the bottom of the hull and then the outdrive cruising at about 35mph. It would have torn that LED light right off. Fortunately ours does not hang down. One in a million shot doc.
.
2002 Cobalt 262
&
2005 Cobalt 263
496 MagHO
(sold )
Erie, PA
Currently boatless (for now)
will fly for food
(CChat moderator)
Big Block Power wrote: Tue Jul 14, 2020 9:29 pm
I like it very nice. Did I see led ss cup holders?
Thank you BBP! No Cupholder LED's yet. I do have Blue LED interior bulbs and Blue LED engine compartment bulbs. I did buy Wetsounds LED Strip lighting, but I have not installed any of that yet. I was thinking about installing the Wetsounds LED strip lighting above the cupholdes, not sure yet.
Big Block Power wrote: Tue Jul 14, 2020 9:29 pm
I like it very nice. Did I see led ss cup holders?
Thank you BBP! No Cupholder LED's yet. I do have Blue LED interior bulbs and Blue LED engine compartment bulbs. I did buy Wetsounds LED Strip lighting, but I have not installed any of that yet. I was thinking about installing the Wetsounds LED strip lighting above the cupholdes, not sure yet.
Ok I'll give you half a pass just for the thought you put in
03Cobalt220 8.1gxi DP
"Kids in Tow2"
"Pot The Jus" Originator :-)
Neenah Wi
#ItsBu'sfault
#FARCON Marine CC Core!
