Hydrohoist UL2 6600 Bunk Position Question......

[SVT Tech]

We upgraded from a 1993 Cobalt 220 to a 2000 Cobalt 262. We have a Hydrohoist Ul2 6600 lift in our slip that we used with the 220. I'm planning on moving the lift back 4 ft to accommodate for the length, but does anyone know if the bunks will need repositioned?

The 1993 220 hull was the same through 1999 if that helps anyone. I meant to measure the 220 trailer bunks, but we sold the 220 yesterday. I'm hopeful the current bunk configuration will work.


Thank you guys!

[cmattj]

As it may appear close in width on the hull . Always measured the distance between the chines ( tape .. string .. and weight) .
That measurement can be used to set your outside to outside distance.

This is done at the transom and then at the hull forward where the bunks reach ( 12 foot bunks go forward 12 feet and tape string weigh again.
Deduct 2 inches and set your bunks. It will center but not rest on the chines.

Sounds tricky but with 2 people it will take 10 minutes and your Cobalt will thank you!